PRODUCT OVERVIEW
Liquid Remediact^™ is a newly developed product that was created to solve soil & water hydrocarbon contamination problems. This product has the ability to bio-remediate most hydrocarbons with a minimum amount of equipment, labor and cost. What sets Liquid Remediact^™ apart from all other products is the high concentration of live synergistic bacteria, in a remediation liquid, that quickly starts the bio-remediation process. Because of it's relatively low cost, Liquid Remediact^™ is the ideal solution for most industries to solve their own hydrocarbon contamination problems.

HOW TO USE THIS PRODUCT
Liquid Remediact^™ is highly concentrated. This product must be mixed in a 10:1 ratio with water. Changing this mixing ratio is not recommended. Each mixed gallon ofLiquid Remediact^™ will remediate 1 cubic yard of soil or approximately 200 gallons of water. The following is the general procedure for using this product.

• Determine the area that is contaminated. This can be done by multiplying the length x width x depth in ft.. Then divide by 27 to determine cubic yards.
• After you have determined the above, plot-out a "matrix" approximately every 3-10 feet on the surface area, depending on soil density. This matrix will be the drilling points for the "Injection Wells" for the Liquid Remediact^™.
• Drill the "Injection Wells" to a depth that is approximately 1-2 feet above the deepest point of contamination. Insert 2" PVC pipe to this depth and cap the bottom. This pipe should be "slotted-screened" pipe, generally found at "well supply companies". It is at these sections that the Liquid Remediact^™ will enter the sub-surface of the terrain. If you are going to inject directly into ground water "pools", please consult the factory.
• Mix the Liquid Remediact^™ at the 10:1 ratio in sufficient quantity to fill all of the well pipes, from top to bottom.
• Fill each pipe with the mixture and put a temporary "cap" on each.
• If possible, insert a 1/4" plastic air tube, through the cap, to the bottom of the pipe.
• Connect all of the air tubes to a central compressor at a pressure of approximately 5-8 lbs. PSI. This air will help to accelerate the bio-remedial process.
• The pipes should be checked for liquid content after 7 days. The liquid level should be maintained above the first slotted section for 2 weeks. Add mixture to maintain this level as needed.
• In approximately 30-45 days there will be significant reductions in the contamination levels. Test the site as dictated by local or managing authority requirements.

FOR OPTIMUM EFFECTIVENESS, A WATER TEMPERATURE BETWEEN 60° F. AND 90° F. SHOULD BE MAINTAINED. DO NOT EXCEED A WATER TEMPERTATURE OF 120° F

APPLICATIONS
The following is a partial list of the hydrocarbons that Liquid Remediact^™ can remediate Please contact SpillAway+ Brands^™, if you have any questions about its usage:

DIESEL FUEL HEATING OIL GASOLINE BENZENE PARAFFIN LUBRICATING OIL PAINT THINNERS MINERAL SPIRITS MOTOR OIL AROMATICS

ETHYLBENZENE JET FUEL CUTTING OILS GLYCOLS ALCOHOL NAPHTHALENE CRUDE OIL TOLUENE KEROSENE

SOLVENTS ANTI-FREEZE ORGANIC PESTICIDES ORGANIC HERBICIDES TRANSMISSION FLUID XYLENE ORGANIC SOLVENTS GREASE TARS

PACKAGING INFORMATION
1 GALLON "CUBITAINERS" (4 per case) - 5 GALLON "CUBITAINERS"